Technical Data - Salda FLEX Données Techniques

EN
CONTROL PANEL WITH THE LIQUID CRYSTAL DISPLAY
„FLEX" Technical manual
Description
The "FLEX" control panel is used for control of ventilation units with
V1, V2, V2.3, V2.4 control boards.
• Program the unit operation modes for one week.
• Set the temperature for supply or extracted air flow.
• Set fan motor rotation speed.
• Indication for the plate heat exchanger's antifreeze protection.
• Fault signal indication
• Indication of the temperatures, humidity and pressure for ambient,
outdoors room, exhaust and supply air.
• Automatic recognition of the controlled unit.

Technical data

Mounting
Voltage
Data transmission
Cable length
Dimensions (WxHxD)
Safety class
Ambient temperature
Ambient humidity
Functionality of buttons
1 "Fast Button" – used for control of the selected function (see II.6.5.3)
2 „ ↑ "– used for increasing the setting values or for moving a line up
3 "OK" – used for confirmation of the selected line or of the set value
4 „ ↑ "– used for decreasing the setting values or for moving a line down
I. Initial window
1.
Unit operation mode is selected
"OFF" – complete switch off of the unit
"Manual" – the unit operates based on the set speed and tempera-
ture
„Schedules" - the unit operates based on the programmed events.,
and/or „Building protection" – minimal ventilation without tempera-
ture maintenance, (see.: Service manual 17.1.).
If no programmed events exist, "( ! )" is shown (see II.2).
10
Surface.
[VDC] 15-30
RS485
[m] 13
[mm] 86x86x16
IP-20
[°C] 10-30(50*)
[%] <90
OK
1 2 3
Manual
Fan speed Schedules ( ! )
Set temperature Manual
Supply air temp. OFF
Deicing
7:28 2013-06-04
www.salda.lt
4
Sk