Velleman CAMCOLBUL16 Notice D'emploi page 4

Overview
5.
Refer to the illustrations on page 2 of this manual.
A heat-resistant fixed ring
B heat-resistant waterproof ring
C 2mm tempered glass
D heat-resistant fixed ring
E light sensor + IR LEDs
1 video
2 power
3 cable exit - backside
4 cable exit - top
Installation
6.
• Choose the location for the camera, keeping following guidelines in mind:
o do not install the camera in locations where extremely high or low temperatures or
excessive vibrations may occur.
o avoid mounting the camera near high electro-magnetic fields.
o do not aim the camera at the sun or other extremely bright objects or reflections (e.g.
metal doors).
o The connection cables run at the inside of the mounting bracket, and leave at the
backside [3] (default). They can be re-guided to leave via the top [4] or bottom [5] of
the mounting bracket.
• When the connection cables need to go through the wall, a hole of at least Ø20mm (max.
Ø35mm) must be foreseen at the mounting location.
• Guide the cables though the cable hole when applicable. Mount the mounting bracket on the
wall using 4 screws (included). Note that the camera must be resting on top of the
mounting bracket.
• Release hex screws [6] and [7] (hex key included) and point the camera to the desired
field of observation. Tighten hex screw [7] to secure the horizontal position and hex screw
[6] for the vertical position.
• Connect the video connector [1] to a monitor (not incl.).
• Connect the power connector [2] to a 12VDC power supply (not incl.).
• Manually adjust the zoom with screw [F] and the focus with screw [G]. These screws are
located at the back of the camera under protective caps. After adjusting, replace the
protective caps.
• The sunshield can be mounted or dismounted by sliding the sunshield towards the front of
the camera.
Technical specifications
7.
IP rating
scanning system
pick-up element
image size
number of pixels
resolution
min. illumination
max. IR projection distance
19/01/2009
CAMCOLBUL16
F zoom adjust
G focus adjust
H 4~9mm varifocal lens
I vandal-proof housing
J sunshield
5 cable exit - bottom
6 hex screw – vertical position
7 hex screw – horizontal position
IP66
PAL
Sony CCD sensor
1/3"
500(H) x 582(V)
420 TV lines
0.8 lux (IR off) / 0 lux (IR on)
± 70m
4
®
Velleman