Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. There are 4 Program buttons for four reprogrammable beverage stations
for easy operation and consistent results. The factory-set stations are
programmed as listed below:
2. To run any of the above preset programs, blender must be in
STANDBY mode.
3. Press desired Program button to start the blender. The motor will run at
the preset speed within the preset blending time. The LCD will show time
remaining. Once the blender counts down to 0, the motor will stop
running and the blender will return to STANDBY mode and prompt
"PRESS ANY BUTTON TO BLEND," to begin another function.
NOTE: To terminate a blending program, simply press START/STOP
button or any of the Program buttons. After doing this, the blender will
return to STANDBY mode and LCD will prompt "PRESS ANY BUTTON
TO BLEND."
Users can add 4 new programs to meet their needs. A program can
consist of several sections, each with a different speed and running time.
For example,
as shown below:
Section 1: speed = 75%; time = 30 seconds
Section 2: speed = 100%; time = 20 seconds
Section 3: speed = 50%; time = 20 seconds
The program has the following limitations:
Speed: 5% to 100%
Time: 5 to 90 seconds
Total running time in a program cannot exceed 90 seconds, i.e., sum
of the sections cannot be longer than 90 seconds.
NOTE: The
during the reprogramming process.
1. To enter new program, press both Speed Up
buttons simultaneously while unit is in STANDBY mode. The blender will
enter new programming mode and the LCD will prompt "ADD NEW
PROGRAM."
2. Next, you will need to set values. Press the Program button you want
to replace (e.g., 1–4). The LCD will prompt "USE UP/DOWN TO SET
SPEED: 25%."
REPROGRAMMABLE STATIONS
Liquid drinks
Frozen drinks
Ice cream drinks
Smoothies
REPROGRAMMING BEVERAGE STATIONS
can be replaced with a new program that has 3 sections,
button will act as the enter key to proceed to the next step
7
and Speed Down
Publicité
Table des Matières
