Waring Commercial XTREME MX Serie Mode D'emploi page 5

8. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
9. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
10. To turn the unit off, press STANDBY
go off.
Warning – This is a Class A product. In a domestic environment this
product may cause radio interference, in which case the user may be
required to take adequate measures.
1. Before starting, make sure that the blender is
unplugged and container is not positioned on the
blender.
2. Put ingredients into container and cover it. Do not
fill above MAX fill line.
3. With the unit in STANDBY
container on blender base. Be sure container is fully seated and that
drive coupling is properly engaged. Plug blender cord into outlet.
4. This blender has variable speed controls. Set blender to desired speed
between 1 and 10.
5. The left paddle switch defaults to the VARIABLE setting in order to use
the speed adjustment option. Press right paddle switch up to the ON
position.
6. When finished blending, set paddle switch to STANDBY
7. This blender is equipped with a PULSE option. Holding left paddle
switch in down position will activate VARIABLE PULSE function (Pulse
speed controlled by knob). If ON/STANDBY switch is set to the ON
position and PULSE switch is activated, then PULSE will operate
at maximum speed of 30,000 RPM. Once PULSE paddle switch is
released, speed will continue to run at variable speed setting.
8. Allow motor to come to a complete stop before removing container
from blender base. Never place the container on the motor base or
remove it from the motor base while motor is running.
9. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
10. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
MX REPROGRAMMABLE CONTROL SETTINGS
1. Before starting, make sure that the blender is unplugged and container
is not positioned on the blender.
2. Put ingredients into container and cover it. Do not fill above MAX Fill
line.
3. Place container on blender base. Be sure container is fully seated and
that drive coupling is properly engaged. Plug blender cord into outlet.
MX VARIABLE SPEED OPERATION
position, place
button. Green LED light will
5
position.