Antenna Connection; Satellite Dish Connection - LG 22LF49 Serie Manuel D'utilisation

CAUTION
Disconnect the power rst, and then move or install the TV.
Otherwise electric shock may occur.
Remove the stand before installing the TV on a wall mount by
performing the stand attachment in reverse.
If you install the TV on a ceiling or slanted wall, it may fall and
result in severe injury. Use an authorised LG wall mount and
contact the local dealer or quali ed personnel.
Do not over tighten the screws as this may cause damage to the TV
and void your warranty.
Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are
not covered by the warranty.
Screw length from outer surface of back cover should be under
8 mm. (Only LF49**)
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
: M4 x L10
Max. 8 mm
NOTE
Use the screws that are listed on the VESA standard screw
speci cations.
The wall mount kit includes an installation manual and necessary
parts.
The wall mount bracket is not provided. You can obtain additional
accessories from your local dealer.
The length of screws may di er depending on the wall mount.
Make sure to use the proper length.
For more information, refer to the manual supplied with the wall
mount.
When attaching a wall mounting bracket to the TV, insert the wall
mount spacers into the TV wall mount holes to adjust the vertical
angle of the TV. (Only when the item of the following form is
provided)
Provided Item
Wall Mount Spacer
Connections (noti cations)
Connect various external devices to the TV and switch input modes to
select an external device. For more information of external device's
connection, refer to the manual provided with each device.
Available external devices are: HD receivers, DVD players, VCRs, audio
systems, USB storage devices, PC, gaming devices, and other external
devices.
NOTE
This TV does not support HEVC codec.
The external device connection may di er from the model.
Connect external devices to the TV regardless of the order of the
TV port.
If you record a TV program on a DVD recorder or VCR, make sure to
connect the TV signal input cable to the TV through a DVD recorder
or VCR. For more information of recording, refer to the manual
provided with the connected device.
Back Cover
Refer to the external equipment's manual for operating
instructions.
If you connect a gaming device to the TV, use the cable supplied
with the gaming device.
In PC mode, there may be noise associated with the resolution,
vertical pattern, contrast or brightness. If noise is present, change
the PC output to another resolution, change the refresh rate to
another rate or adjust the brightness and contrast on the PICTURE
menu until the picture is clear.
In PC mode, some resolution settings may not work properly
depending on the graphics card.

Antenna connection

Connect the TV to a wall antenna socket with an RF cable (75 Ω).
Use a signal splitter to use more than 2 TVs.
If the image quality is poor, install a signal ampli er properly to
improve the image quality.
If the image quality is poor with an antenna connected, try to
realign the antenna in the correct direction.
An antenna cable and converter are not supplied.
Supported DTV Audio: MPEG, Dolby Digital, Dolby Digital Plus,
HE-AAC

Satellite dish connection

(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω).
11