Dmx Connection - Chauvet Professional Amhaze Stadium Guide De Référence Rapide

DMX Connection

The AmHaze Stadium uses a 3- or 5-pin DMX data connection for its 2-channel DMX personality. See the User Manual
for information about connecting and configuring the product for DMX operation.
Preparing for Operation
To prepare the AmHaze Stadium for operation:
1. Open the flight case.
2. Pull out the fluid tank and remove the cap.
3. Verify that the two plastic hoses attached to the inside of the cap are in place and in good condition.
4. Pour Chauvet (PHF) haze fluid inside the tank, and re-cap.
5. Reinsert the tank.
6. Make sure that the plastic hose that goes from the cap to the hazer is not bent.
7. Plug in power and wait approximately 30 seconds for warm-up to complete.
When storing the product, ALWAYS be sure to store the fluid tank with the cap up as seen on the
Product Mounting Diagram above before installing the front cover to avoid tube damage that may
cause leakage.
Only use Chauvet approved (PHF) haze fluid. Otherwise, you might not have satisfactory results.
In addition, unapproved fluid can damage the AmHaze Stadium or cause harm to humans or
animals.
AmHaze Stadium QRG Rev. 3
QUICK REFERENCE GUIDE
EN
3