With Pto Vario-Drive Fan - HE-VA Terra-Seeder 3 m Mode D'emploi Et Liste Des Pièces De Rechange

Table des Matières

Publicité

Terra-Seeder
29-10-2010
Mounting of Fanterra on Tractor

With PTO Vario-drive fan

The vario-pump is installed in the tractor PTO.
In order to attach this and avoid rotation during the
operation, the fittings shall be adapted to the tractor model
in question.
The length of the arms A, B and C are adjusted so that the
rivet fits in the bottom hole in the top link attachment of the
tractor.
It may be necessary to shorten the arms by means of an
angular grinder.
REMEMBER to tighten bolts, etc., before the use.
When the vario-pump is installed on the tractor, the PTO-
RPM amounts to 1000.
The gear case is filled with 0.2 l oil.
The oil level may be checked by means of the control screw
at the side of the gear case.
With 1000 PTO-RPM on the tractor, the blower RPM is
adjusted with screw tap placed inside the blower. The
blower RPM may be read on the Seed-Controller, and the
alarm shall be adjusted to the required blower RPM.
(See the instruction manual for Seed-Controller)
In case of low outside temperatures, the blower shall run to
be warm for approximately five minutes before stable
revolutions are obtained.
If the Fanterra is equipped with "Vario-drive", the oil level of
the blower shall be checked every 10 operating hours at the
dip stick in the filling plug.
In case of lack of oil, you must fill up until the maximum
level at the dip stick.
The blower shall contain 17 l Wintershall ATF DEXRON
Shell ATF DEXRON II or Castrol TQ DEXRON II.
It is recommended to replace oil and filter once a year.
22

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Terra-seeder 4 mTerra-seeder 5mTerra-seeder 6 mTerra-dan

Table des Matières