Table des Matières
Publicité
Safety and Instructions as regards the Hydraulic System
6. The maximum permissible working pressure amounts to 225 bar.
7. It is recommended to mark the coupling parts of hydraulic connections between tractor and tool in order to
avoid incorrect operation!
8. In connection with check for leaks, suitable protective clothing should be used due to the danger (eye
protectors, gloves, etc.)
Hydraulic oil under high pressure may penetrate the skin and cause dangerous injuries.
In case of injuries, you must consult your doctor immediately. DANGER OF INFECTION!
9. Before working with the hydraulic system, you must lower the machine to solid ground. The pressure shall be
relieved, the motor stopped and the ignition key removed.
10. The hydraulic hoses shall be inspected on a regular basis, however, every six months, as a minimum, for cracks,
wear, etc. Defective hoses shall be replaced immediately.
The life for the hydraulic hoses is maximum five years.
New hydraulic hoses shall comply with the manufacturer's requirements.
INSTRUCTIONS CONCERNING TRANSPORT ON PUBLIC ROADS
Before you drive on public roads, you must check that the coupling of the machine with the tractor is in accordance with
the valid road traffic acts (permissible overall weight, permissible axle load, transport width, lights, and warning signs).
FRONT-AXLE LOAD
Check that the front-axle is sufficiently loaded. The front-axle load should be a minimum 20% of the weight of the
tractor. It is advised that you use a front mounted press rather than ballast.
If you use a front press the tractor will stay balanced both in work and turning on the headland as well as reducing soil
damage.
NB ! The driving, steering and braking qualities are influenced by the mounted machine combination.
Terra-Seeder
21
29-10-2010
Publicité
Table des Matières
