Warranty Conditions - Eldom Invest 72324NMB Manuel D'installation, Utilisation Et Entretien

EN
only a slightly damp soft cotton cloth and never with invasive
and/or abrasive substances and preparations. Before cleaning the
appliance, it MUST be disconnected from the power supply by
unplugging the plug on the power cord. IT IS FORBIDDEN to clean
the appliance with steam generator. Particular attention should be
paid to prevent wetting of the appliance light switch on its control
panel. The plug of the cord can be plugged into the socket only
after complete removal of moisture.
The rules for checking the anode protection and anode
replacement (please refer to previous section), as well as removal
of the accumulated limestone, must be strictly observed both
during and after the appliance warranty period.
During the appliance usage and maintenance do not damage the
metal plate with its technical data and serial number. Should you
take it off, keep it with the warranty form because it is the document
serving to identify the water heater.
FAILURES
When the heater does not heat the water, check if the power cord
plug is plugged, if the lighting key is switched off and if the
thermostat knob is not turned to the lowest position.
If the power supply is in order, the lighting key is switched on and
the thermostat knob is turned to its highest position, but the water
in the appliance is still not warming (it is possible that the lighting
key or the signal lamp are lighted or not), using the external
disconnecting device unplug the heater plug from the power cord
and contact the nearest authorized service company.
In case when from the mixer at completely open tap for hot water
there is no leakage or water flow is weaker than normally, check
that the inlet mixer nozzle of the instruments with free flow is not
clogged, or if the filter at the mixer outlet is not clogged, or whether
the shut-off valve before the heater is not fully or partially closed (4
of Fig. 11), or if water supply is not stopped. If all listed above
causes are not the cause of failure, unplug the plug on the power
cord or using the external disconnecting device unplug the heater
and contact the nearest authorized service company.
Failure of the mixer of a water heater leak free and requires
replacement with a new one, it must be of the same type or of a
type approved by the manufacturer of the tank. It is imperative to
contact a competent specialist in this field, as we recommend it to
be representative of the manufacturer or its authorized service
company. The installation of improper and / or unapproved mixer is
a danger! It is forbidden to use the device with such a mixer!
In case of failure of the power cord and plug of contact the nearest
authorized by the manufacturer service company as the cord with
plug must be replaced by the manufacturer, its service agent, or a
person with similar qualifications in order to avoid danger.
WA R R A N T Y, WA R R A N T Y P E R I O D A N D

WARRANTY CONDITIONS

The warranty, warranty conditions, warranty period, warranty
validity for purchased appliance and service related manufacturer
or vendor liabilities during the appliance warranty period are listed
in the appliance warranty form. When buying the appliance the
warranty form must be filled and signed both by seller and buyer.
Keep the warranty form in a secure place.
In all instances shall be in force the applicable laws, regulations
and other legislation dealing with the rights and obligations of
consumer, seller and manufacturer, and their relationships related
to purchased water heater, its installation, use, servicing and
maintenance.
Warranty term is determined by seller and is in force only for the
geographical territory of the country.
Warranty is valid only if the appliance:
Is installed according to the requirements for installation and
џ
operation.
Is used only as per designed purpose and in accordance with
џ
the installation and operation manual.
Warranty consists of free of charge repair of all factory defects,
which may arise during the warranty term. Repair is performed by
service specialists, authorized by seller.
Warranty is not valid for damages, caused by:
Improper transportation
џ
Improper storage
џ
Improper usage
џ
Parameters of water, different from the admissible norms for
џ
quality of drinking water, and particularly if: the composition of
chlorides is more than 250 mg/l; the electrical conductivity is
less than 100 μS/cm and pH is outside of 6,5-8 for water
heaters with enameled water tanks; the electrical
conductivity is more than 200 μS/cm for water heaters with
water tanks made of chrome-nickel steel.
Supply voltage, different than the unit's rated voltage.
џ
Damages due to freezing of water.
џ
Elemental perils, disasters and other force majeure
џ
circumstances.
Non observance of the installation and operation manual.
џ
In cases, when a non authorized person has tried to repair
џ
any kind of a defect.
In the above cases the defect will be repaired against relative
payment.
Warranty shall not apply to normal wear parts and components of
the device, parts that are removed during normal use, lighting and
signal lamps and the like, re-painting colour of external surfaces,
change of shape, size and location of parts and components that
are exposed to impact and conditions that are not considered
normal use.
Lost profits, tangible and intangible damages caused by
temporary inability to use the device during its prevention and
repair shall not by covered by the warranty.
COMPLIANCE WITH THE REQUIREMENTS OF THIS
INSTRUCTION MANUAL IS A PREREQUISITE FOR SAFE
OPERATION OF YOUR PURCHASED PRODUCT AND IS
ONE OF THE WARRANTY TERMS AND CONDITIONS.
IT IS ABSOLUTELY PROHIBITED TO THE USER OR ANY
AUTHORIZED BY HIM PERSON TO UNDERTAKE ANY
C H A N G E S I N T H E P R O D U C T D E S I G N A N D
STRUCTURE. ANY FINDING OF SUCH ACTIONS OR
ATTEMPTS SHALL AUTOMATICALLY RENDER VOID ALL
WARRANTY LIABILITIES OF SELLER OR PRODUCER.
IN CASE OF NECESSITY FOR SERVICE SEEK ONLY
MANUFACTURER AUTHORIZED SERVICE COMPANIES
LISTED IN THE ANNEXED FORM.
THE MANUFACTURER PRESERVED HIS RIGHT TO
STRUCTURAL CHANGES WITHOUT NOTICE WHERE
SUCH SHALL NOT AFFECT PRODUCT SAFETY.
13
EN