To Start The Product - Zenoah BCZ260L Manuel D'utilisation

2. Move the choke control up into choke position.
To prepare the product for start (BCZ400L)
1. Press the primer bulb repeatedly until the fuel begins
to fill the bulb.
Note: The bulb does not need to be filled completely.
2. Move the choke control clockwise to choke position.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start th
product (see
WARNING: When the engine is started with
the choke in either the choke or start throttle
position the cutting attachment will start to
rotate immediately.
1. Use protective gloves.
353 - 003 - 06.01.2018
Safety on page 5 ).
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Grip the starter handle.
4. Slowly pull out the cord with your right hand until you
feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter cord
around your hand.
5. Pull the cord quick and with power.
CAUTION: Do not pull the starter cord all
the way out and do not let go off the
starter handle when the cord is fully
extended. This can damage the product.
6. Reset the choke when the engine fires.
7. Repeat to pull the cord until the engine starts.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
WARNING: Do not put any part of your body
in the grey marked area. Contact can result
in burns to the skin, or electrical shock if the
spark plug cap has been damaged.
17