Electrical Warnings - IKEA FULLGORA Mode D'emploi

ENGLISH
place suitable for its size and use. Make
sure the appliance is not near a heat
source and that the four feet are stable
and resting on the floor, adjusting them
as required, and check that the appliance
is perfectly level using a spirit level. Wait
at least two hours before switching
the appliance on, to ensure that the
refrigerant circuit is fully efficient.
To guarantee adequate ventilation,
leave a space on both sides and above
the appliance. The distance between
the rear of the appliance and the wall
behind the appliance should be 50 mm, to
avoid access to hot surfaces. A reduction
of this space will increase the Energy
consumption of product.
WARNING: When positioning the
appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to
instability, positioning or fixing of the
appliance must be done in accordance
with the manufacturer instructions. It's
forbidden to place the freezer in such way
that the metal hose of gas stove, metal
gas or water pipes, or electrical wires
are in contact with the freezer back wall
(condenser coil).
To guarantee adequate ventilation,
leave a space on both sides and above
the appliance. The distance between
the rear of the appliance and the wall
behind the appliance should be 50 mm, to
avoid access to hot surfaces. A reduction
of this space will increase the Energy
consumption of product.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by
a multi-pole switch installed upstream of
the socket in accordance with the wiring
rules and the appliance must be earthed in
conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to
the user after installation. Do not use the
appliance when you are wet or barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if it is
not working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard - risk of electric shock.
WARNING: Do not locate multiple
portable socket-outlets or portable power
supplies at the rear of the appliance.
Feet of the product: in Fs not available;
in built in - the "feet are not adjustable -
and the METOD cabinet should be levelled
with spirit level.
7