GO/ON A007G-07C Mode D'emploi page 42

Original instruction manual
TROUBLE SHOOTING
Troubles
1. UNIT DOES NOT
START WHEN
PRESSING POWER
BUTTON
2. Not cool enough
3. Noisy
4. E0 Code
5. E2 Code
8
Possible Causes
Water full indicator lamp blinks, and
water tank is full.
Room temperature is lower than the
setting temperature.
mode)
The doors or windows are not
closed.
There are heat sources inside the
room.
Exhaust air hose is not connected
or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat
enough
The sound comes from the flowing
of the refrigerant inside the air
conditioner
Room temperature sensor failed
Water pump failed.
Suggested Remedies
Dump the water out of the
water tank.
Reset the temperature
(Cooling
Make sure all the windows
and doors are closed.
Remove the heat sources if
possible
Connect
exhaust air hose.
Reset the temperature
Clean the air inlet.
Place the unit on a flat,
level ground if possible
It is normal.
Replace room temperature
sensor (the unit can also
work without replacement.)
- Restart the unit, and the
failure may disappear.
- Replace water pump.
En
or clean the
10/2018