GO/ON A007G-07C Mode D'emploi page 38

Original instruction manual
Placement:
Place the machine on flat and dry ground, and keep it far from around things at least 50cm.
(picture 2)
Installation:
· Spin slide bar connector into exhaust hose first, then spin the exhaust hose into exhaust
connector (counter-clockwise).
· Put slide bar connector into adjustable slide bar, adjust window open width in order slide bar
match window well, and the length of slide bar is adjustable. (picture 3)
(picture 3)
Warning
Length of exhaust pipe according to the machine features, please don't replace or lengthen it
freely, otherwise errors will be easily caused.
Note: extreme length of unfolding exhaust pipe is 1500mm, please shorten the length as
much as possible and keep it level as much as possible when installing.
Installation Errors:
· Free access of exhaust pipe is important, installation errors will bring bad influence of machine.
· Avoid exhaust-pipe with sharp bend. (picture 4)
· Make sure air in exhaust pipe can run smoothly. (picture 5)
4
En
(picture 2)
10/2018