Rehaforum MEDICAL Actimo Arthro Mode D'emploi page 8

Instructions / Assembly
1. Remove the pre-assembled
walker from the box and check
the contents and the
packaging for damage or
completeness.
2. Fold the chassis of the walker
outwards by pressing down
the seat on both sides until it
clicks into place.
3. Insert tubes with arthritis pads
into the frames of the rack.
Loosen the knob screw at the
tube holder, push or pull the
handle tube to the desired height (holes for fixing)
and tighten the knob screw again. Make sure that
the same height is set on both sides. The brake
cables extend in parallel to the frame.
4. To adjust the distance between the brake / handle
and the arthritis pad, unscrew the nut below the
pad and remove the screw from above. Pull the
handle outwards until the desired distance is
reached and insert the nut back into the opening
from above. Insert it all the way and then tighten
the nut again from below. The distance should be
the same on both sides.
5. Attach the bag using the Velcro
fasteners on the suspension device and the
lower portion of the frame.