Reprogramming Procedure - CAME 001DC01EARY Mode D'emploi



Reprogramming procedure

PROG
a
SW3

beep



Exiting programming. Briefly press the PROG key : the PROG LED off. NOTE. If no action is performed, the procedure will automatically end after 30 minutes.
Programming key type. At the "Programming Call Buttons" stage, press the PROG  key for at least 3 seconds and then release it (within 6 seconds), as
soon as the LED PROG lights up and the key back lighting flashes as illustrated in figure , entering "Programming Button Types/Combinations" as part
of the procedure.
Press the first key of the entry panel in the position indicated  until the backlighting LED stops flashing  and remains lit.
At the end, exit programming, briefly press the PROG key : the PROG LED will turn off. If no action is performed, the procedure will end automatically
after 30 minutes.
001CK0010-14FR-15FR 24810650 05-08-14_EN

>3''
Entering Programming Mode. Press the PROG a key for at least 3 seconds and then release it (within
<6''
6 seconds) as soon as the LED PROG light flashes and the key back lighting lights up as illustrated in
figure . Failure of the PROG LED to light up, indicates a malfunction. Check the connections and
re-access the programming mode.
PROG

SW3
Programming the call keys. Lift the receiver (if present) of the extension that you want to programme
 then press the door lock release
key to be associated with the internal extension : an acoustic signal will confirm that the setting
was stored. Hang up the receiver again, if necessary  and continue, repeating the same operations
for the other extensions.

PROG
BOUT

SW3
<1''
PROG
SW3
<1''
PROG
SW3
PROG
M1
SW3
M2
Exiting programming. Briefly press the PROG
key : the PROG LED off. NOTE. If no action is
performed, the procedure will automatically end
after 30 minutes.

and AUX2  buttons. On the entry panel, press the call

M1
BOUT

>3''
<6''
PROG
SW3
PROG
SW3
M2
11