Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Melody setting
For call programming, see the entry panel documentation.
a
4
3sec
3sec
... beep!
... beep!
Accessing programming. Press and hold the key for 3 seconds. A brief acoustic signal and
3sec
... beep!
the blinking LED will confirm that programming has been accessed a.
3sec
3sec
... beep!
... beep!
Programming the melody associated to the call from the entry panel (1 acoustic signal).
To hear the melodies in sequence, press the key . To select the melody and exit the
programming, press the key . To select the melody and continue with programming,
press the key
3sec
3sec
... beep!
... beep!
Programming the melody associated with the doorbell (2 acoustic signals). For this
type of programming proceed as previously described for "Programming the melody
associated to the call from the entry panel".
Programming the number of call rings (3 acoustic signals). Press the key the number
of times equal to the rings selected for the call (1 to 6 rings) . 3 s after the key is pressed
the last time, the call selected for the selected number of rings will be will be reproduced. To
save the new settings, press the button ; otherwise, press the door lock release button
(
.
) to enter the entry panel call melody programming procedure again.
001CK0010-14FR-15FR 24810650 05-08-14_EN
Publicité
Table des Matières
