Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
F
G
I
2
8
B
a
A
1
During installation of the recessed box it is possible to avoid any deforma-
tion by using the provided spacer F . With the allen wrench unscrew
the blocking screws and remove the entry panel plate A. Introduce the
cable connections in the special hole B and fix the entry panel on the
frame as shown in figure G; extract the plastic terminal cover and wire
the connections D.
Once the connections have been made and re-insert the terminal covers.
For the installation of the accessories refer to the chapter "Button module
installation".
Perform the programming and adjustment operations of the entry panel as
described to the chapter "Programming". Install the front plate A.
Button module installation
Insert the button module as highlighted H paying special attention to the
top to bottom orientation J.
Remove the glass and write the user names I, paying special attention to
the orientation of the glass J.
H
J
001CK0010-14FR-15FR 24810650 05-08-14_EN
Publicité
Table des Matières
