Zephyr Preserv PRB24C01BG Guide D'utilisation, D'entretien Et D'installation page 8

Refroidisseur de boissons à une zone
Masquer les pouces Voir aussi pour Preserv PRB24C01BG:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety Information
Attention
Never overload the cabinet.
Never open the door unless necessary.
Never cover shelves with aluminum foil or any other shelf material which may
prevent air circulation.
Should the appliance be left empty for long periods, it is suggested that the
appliance be unplugged, and, after careful cleaning, leave the door ajar to allow
air to circulate inside the cabinet in order to avoid possible condensation, mold or
odors from forming.
Electrical Connection
Check that the voltage marked on the product corresponds with your supply voltage.
WARNING: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by a qualified electrician or an
authorized service center.
This appliance should be properly grounded for your safety. The power cord of this
appliance is equipped with a three-pin plug which mates with standard three-pin wall
outlets to minimize the possibility of electrical shock.
Never under any circumstances cut or remove the third ground prong from the power
cord supplied. For personal safety, this appliance must be properly grounded.
with three pins. Have the wall outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded. When a standard two-pin wall outlet is
encountered, it is your responsibility and obligation to have it replaced with a properly
grounded three-pin wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and
not left exposed or dangling.
The appliance should always be plugged into its own individual electrical outlet which
has a voltage rating that matches the rating label on the appliance. This provides the
best performance and also prevent overloading wiring circuits that could cause a fire
hazard from overheating. Never unplug the appliance by pulling the power cord.
Always grip the plug firmly and pull straight out from the receptacle. Repair or replace
immediately all power cords that have become frayed or otherwise damaged. Never
use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
Never use your appliance with an extension cord unless this cord has been checked
and tested by a qualified technician or service person. The extension cord must be a
UL/CUL Listed, 3-wire grounding extension cord that has a grounding plug and outlet
and that the electrical rating of the cord is 115 volts and at least 10 amperes.
8

Publicité

Chapitres

Table des Matières
loading

Table des Matières