Whirlpool HGL 44 A Manuel D'instructions page 24

WASH PROGRAM WITH CRV (IF INSTALLED):
The wash program ends with a steam extraction and recovery phase.
The countdown indicates the remaining time to the end of this phase. You are
recommended NOT to open the door during the recovery time, as this will help to save
electricity.
Last phase: 30 seconds activation of the fan with scrolling written indication.
EMPTYING AT THE END OF THE DAY (for versions with overflow)
To shut the machine down at the end of the day, switch off the button.
Open the door and remove the overflow. You can activate the AUTOCLEAN function by
pressing (blue) as long as the icon is displayed.
Only for models N1300 DOUBLE, insert one empty basket in order to activate
the switch.
The AUTOCLEAN function is confirmed by icon.
The dishwasher will be completely emptied until the countdown ends.
Tank emptying in progress.
EMPTYING AT THE END OF THE DAY WITH CRV (IF INSTALLED):
Dishwashers equipped with the CRV system have the AUTOCLEAN function of the suction
line.
The display shows this phase for 40 seconds.
Emptying with CRV and related icon.
If there is still water in the tank (overflow not removed) at the end of the emptying time, the
display will show the tank full icon for 25 seconds.
EMPTYING AT THE END OF THE DAY WITH AUTOMATIC DRAINAGE
To shut the machine down at the end of the day, switch off the ON/OFF button.
You can activate the AUTOCLEAN function by pressing START (blue) as long as the icon is
displayed.
Only for models N1300, insert one empty basket in order to activate the
switch.
Once the machine has been emptied, it will remain in stand-by or OFF mode.
Once you have switched the wall-switch off and shut off the water stop cock, remove the
filters, wash the inside of the tank and the filters with suitable products and put the filter and
the overflow back in the tank.
"NO SALT" INDICATOR (VERSIONS WITH SOFTENER):
Salt for dishwashers is fundamental for the regenerative cycle of the softener installed in the
machine. The display will point out that there is not enough salt in the container inside the
tank. To top-up, use the funnel supplied and clean any spilled salt from inside the tank. "No
Salt" indicator.
NB: REMOVE ANY SPILLED SALT FROM THE TANK IMMEDIATELY, otherwise it could
damage the surface of the tank with rust or similar marks.
24