Blind Hem Stitching - Singer C430 Manuel D'instructions

Table des Matières

Publicité

BLIND HEM STITCHING

The hem is sewn without stitches showing on right
side of fabric.
No. 9 Blind hemming for stretch fabric.
No. 10 Blind hem for non-stretch fabric.
Blind Hem Foot (D)
1. Fold the fabric as shown in the illustration.
a. Medium, Heavy weight fabric
b. Light weight fabric
c. Wrong side of fabric
d. Overcasting
2. The guide (e) on the blind foot ensures even
feeding of the fabric when blind hem stitching.
The guide (e) is adjusted by turning the
adjusting screw (f).
3. Place fabric so that the straight stitches (or
small zigzag stitches) are on the protruding hem
edge and the large zigzag stitches just catch
one thread of the folded edge (g). If necessary,
turn the screw (f) to adjust the foot so that the
needle barely touches the folded edge of the
fabric.
4. Lower the presser foot and sew hem, guiding
fabric evenly along the guide.
5. Turn the fabric over when you have completed
sewing.
c. Wrong side of fabric
h. Right side of fabric
Note: Test on a scrap piece of fabric similar
to your project so you can determine the best
placement of the foot's guide.
62
5mm
1cm
5mm

Publicité

Table des Matières
loading

Table des Matières