Di4 Aspirovac Flex 25.6V Mode D'emploi page 16

• Do not submerge the appliance in water or any other liquid. Make sure that no water enters the appliance.
• Remove any dirt (hair and other fibers) tangled around the brush and wheels.
CLEANING DUST CONTAINER AND FILTER
1. Uncouple the handheld vacuum cleaner. Dismantle it by pressing the release button for dust con-
tainer. 2. Take out the Hepa filter and filter protector. Empty the dust container and filter. 3. If the
parts are heavily soiled, wash the dust container, filter and its protector under running water with
detergent. Check that all the parts are completely dry before fitting them back.
CLEANING BRUSH
1. Unlock the brush from the suction head. Take it out and remove any dirt (hair and other fibers)
tangled around the roller. 2. Wash the brush under running water with mild detergent. Make sure that
it is completely dry before replacing it.
TROUBLESHOOTING
MALFUNCTION POSSIBLE REASONS
MOTOR DOES Battery is power off
NOT TURN ON
The hand-held vacuum cleaner
is not properly installed in the
body assembly (because the
body assembly requires a hand-
held vacuum cleaner to provide
power, which itself cannot work
independently)
SUCTION Dust cup has been full of dust
REDUCED
The Filter is full of dust
Air duct of the Electric brush is blocked
or roller brush stall
The battery is low
CHARGING The hand-held vacuum cleaner is not
INDICATOR DOES fitted to the body assembly
NOT FLASH
RECYCLE WHEN
CHARGING
16
SOLUTIONS
Charge the vacuum cleaner
Correctly install the hand-held
vacuum cleaner and body assembly
Dump the dust in the dust cup
Clean or replace the Filter
Clean the garbage
attached to the electric roller brush
Fully charge the battery as indicated
in the charging section
Properly assemble the hand-held
vacuum cleaner and the body
assembly