Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Programming the automatic start - Cleaning and maintenance - Descaling
•
Models with glass carafe: close the frontal door and
place the closed glass carafe on the non stick warming
plate (fig. 6).
Models with thermal carafe: Before placing the carafe
on the plate, make sure the lid is closed (fig. 7).
•
You can enhance the flavor of your coffee by pressing the
AROMA button. This feature activates a unique brewing
process, slowly releasing water into the filter basket; sa-
turating coffee grounds a little at a time extracting the
best flavor and aroma from your coffee. To activate, press
the AROMA button; the display shows AROMA indicating
the function is selected. Press the button again to turn
the selection off. It is recommended to use the aroma but-
ton if not brewing a whole carafe of coffee.
Press the ON/OFF button (fig. 10). The light indicates that
the coffee maker is in operation and the display shows
"BREW".
The coffee will begin to emerge after a few seconds. It is
•
completely normal for the appliance to release a
little steam while the coffee is brewing.
In models with glass carafe, if you leave the appliance
•
switched on after brewing is finished, the non-stick war-
ming plate will keep the coffee at the ideal temperature.
The unit automatically shuts off after two hours.
•
Models with thermal carafe: To pour the coffee, turn
the lid to the position shown in (fig. 8). To completely re-
move the lid from the carafe, turn it to the position shown
in (fig. 9). The appliance switches automatically off after
brewing cycle.
Important: Removing the carafe before the machine
has finished producing the coffee does not interrupt the
brewing process, but simply stops the flow of coffee into
the carafe. If you want to pour out a little coffee before
brewing is completed, do so as quickly as possible to
avoid coffee overflow.
Freshness indicator
The freshness indicator shows the time elapsed since the
coffee was prepared. Two hours after coffee preparation, the
appliance goes off.
PROGRAMMING THE AUTOMATIC START
Make sure that the time is set correctly.
To program the time to start coffee preparation:
•
Press the SET TIMER button and keep it depressed until
you reach the desired switch-on time.
•
Then release the SET TIMER button. The time will flash for
a few seconds until set: then the display will show the
current hour.
Activating the timer
After you have:
-
set the time for switch-on as described in the previous
section;
-
prepare the machine for making coffee. Press the AUTO
button. The display shows AUTO indicating the coffee
maker is in operation.
CLEANING AND MAINTENANCE
Before carrying out any cleaning operations, switch the ap-
pliance off, unplug it from the power outlet, and let it cool
down.
•
Do not use solvents or abrasive detergents to clean the
appliance. A soft damp cloth is sufficient.
•
Never immerse the coffee maker in water: it is an electri-
cal appliance.
•
If necessary:
-
unhook the inspection's lid (fig. 11-12-13): the appliance
must be switched off and disconnected!
-
always close the lid and insert the chlorine filter holder
before using the appliance.
DESCALING
If the water in your area is hard, lime scale deposits may build
up over time. These deposits may affect the correct operation
of the appliance.
When CLEAN flashes on the display, you have to descale the
appliance using commercially available descalers specifically
for drip coffee machines.
Follow the instructions provided with these products.
1. Dilute the descaler in the carafe, following the directions
on the packaging of the descaler.
2. Pour the descaling solution in the water compartment;
3. Put the carafe on the non stick plate;
4. Press the CLEAN button.The CLEAN program automatical-
ly performs a series of supplies to remove the lime scale
from inside the appliance
5. The program has ended when CLEAN disappears on the
display.
6. Rinse by operating the machine with water only for at
least three cycles (3 full tanks of water).
The warranty is not valid if the cleaning operation described
above is not carried out regularly.
It is recommended to descale the appliance after 60
uses.
7
en
Publicité
Table des Matières
