I Control Of The Device Control Terminals; I Double-Drive-Thru Connections - Panasonic WX-T3020 Mode D'emploi

I Control of the device control ter-
minals
The device control terminals of the center module can be
controlled through the Order Taker.
1. Hold down the C button. A short beep is heard from the
speaker of the headset and a connection will be made
toward the device control terminals of the center mod-
ule.
Hold down
2. Release the C button. A short beep is heard twice from
the speaker of the headset and the connection will be
disconnected toward the device control terminals of the
center module.
Release

I Double-Drive-Thru connections

When Double-Drive-Thru connections are made with the
center module, any Order Taker is required to select the
center module of either Lane A or Lane B.
<For Normal setup>
1. When a connection is made to Lane A, the lane indicator
is lit in yellow. Press the T2 button if you want to make a
connection changeover to Lane B. When connected to
Lane B, a voice of [Lane B] is heard from the speaker of
the headset and the lane indicator is lit in green.
Press
2. While a connection is maintained to Lane B, the lane
indicator is lit in green. Press the T2 button if you want to
make a connection changeover to Lane A. When con-
nected to Lane A, a voice of [Lane A] is heard from the
speaker of the headset and the lane indicator is lit in yel-
low.
Press
<For Direct Lane Select setup>
1. While a connection is maintained to Lane A, the lane
indicator is lit in yellow. Press the T2 button if you want
to make a connection changeover to Lane B. When con-
nected to Lane B, a voice of [Lane B] is heard from the
speaker of the headset and the lane indicator is lit in
green.
Press
2. While a connection is maintained to Lane B, the lane
indicator is lit in green. Press the T1 button if you want to
make a connection changeover to Lane A. When con-
nected to Lane A, a voice of [Lane A] is heard from the
speaker of the headset and the lane indicator is lit in yel-
low.
Press
Note: When Direct Lane Select is set, TALK is available by
selecting either lane pressing T1 or T2 button.
11