Troubleshooting - Roborock S5 Max Mode D'emploi

Troubleshooting

If an error occurs during cleanup, the power indicator will flash red quickly, and a voice alert will play. Refer to the table below
for resolution options.
Error
Error 1: Rotate the laser head to check
that it turns freely.
Error 2: Clean and lightly tap the bumper.
Error 3: Move the robot to a new
location and restart.
Error 4: Wipe the cliff sensors, move the
robot away from raised edges, and restart.
Error 5: Remove the main brush and
clean the brush and bearing.
Error 6: Remove and clean the side brush.
Error 7: Look for anything stuck in the
main wheels then move the robot to a
new location and restart.
Error 8: Clear away any obstacles
around the robot.
Error 9: Install the dustbin and filter.
Error 10: The filter is either wet or blocked.
Solution
The LDS unit is jammed. Remove any items blocking it then move the robot to a new location
and restart.
The bumper is stuck. Tap the bumper repeatedly to dislodge any jammed items. If nothing
falls out, move the robot to a new location and restart.
A wheel is suspended. Move the robot to a new location and restart.
The robot is suspended. Move it to a new location and restart. If the problem persists, clean the
cliff sensors. This error may also be caused by a dirty cliff sensor. Try wiping all sensors clean.
The main brush may be tangled up. Remove and clean it.
The side brush may be tangled up. Remove and clean it.
The main wheels may be jammed. Remove and clean them.
The robot may be stuck. Clear any obstacles around it.
Reinstall the dustbin and filter and check that they are installed properly. If the problem
persists, try replacing the filter.
The filter is not completely dry. Dry the filter for at least 24 hours. The filter may also require
cleaning. If the problem persists, replace the filter.
28