Front Wheel - Yard force Easymow 260B Guide D'installation D'origine

GB
Related to before/during/after charging
Problem Possible cause
Incorrect wire conection
No light on charge base
AC Power has not switched ON
S1/S2 indicator flashes Boundary wire broken, no signal
Machine not correctly docked in
charge base
Robot not charging Machine not correctly docked in
charge base
Charger pins corroded
Related to mowing
Problem Possible cause
ON/OFF key has not been
No Power to machine
activated /turned correctly
Robot mower has Low charge
Time setting not activated
Grass build up under deck
Battery Power Low
Machine fails to START
Grass too long
Cutting height is too Low
Battery temperature too cold /hot
Boundary wire cut
Mower outside the
Boundary wire is on a slope
boundary wire
Parts of the lawn are Mower needs more cutting time
uncut
Grass too long
Obstacles on lawn
Mower gets stuck in Lawn Boundary wire not correct laid
area
Wire in front of docking station
incorrect installed
Blade loose
Blades damaged jammed
Excessive vibration/noisy
Grass maybe to high
Cutting motor failure
Corrective action
Check wire connections " F and B"
Switch on AC power
Repair broken cable with provided
connectors
Check machine is fully docked in
charge base
Check charge base is on flat
surface
Clean the charger pins
Corrective action
Recheck - Turn ON/OFF key knob
to 1
Place machine in the charge base
Select time schedule 3-/ 6hrs -
press and OK buttons
Clean under deck with brush
Place machine in charge base
Mow the lawn to 45mm
Mow the lawn to 45mm and raise
cutting height
Working condition is between 5
o
and 45 C
Repair broken boundary wire
Modify boundary wire and leave
bigger distance on slope
Increase scheduled cutting time to
6hrs
Mow the lawn to 45mm
Remove obstacles from the lawn
Modify boundary wire to zone out
obstacles
2m of straight cable to front of
dockking station needed
Tighten screw bolt
Replace damaged blades
Increase cutting height, reduce
later step by step or mow the lawn
with ordinary lawnmower first
Please call after sales service
16
Problem Possible cause
Power cable runs parallel/close to
wire
Front wheel is stuck
Signal interfere with robot in
Mower runs in circles neighborhood
Driving motor failure
Connection issue or broken/cut
boundary wire
Mower powered off
After repower or manual
and later powered on,
interruption, mower needs to
and it does not mow as
input work commanding again
scheduled time
Corrective action
Reposition of boundary wire
Clean front wheel area
Change to alternative boundary
signal (S1/S2)
Please call after sales service
Repair/check connections on
charge base and boundary wire
being broken/cut
Press "Start + OK" or "Home +
OK", this will let mower return to
normal status
17
GB