Dkn Wifi Controller Connection - Airzone AZAI6WSCDKA Mode D'emploi

DKN WiFi Controller Connection

The DKN WiFi Controller has 4 connecting wires: 2 for communication with the Daikin unit
(red and black) and 2 for the power supply. Follow these steps to connect them:
1. Locate the P1 P2 terminals and the X35A or X18A connector of the Daikin
indoor unit (where the thermostat connects).
2. Connect the communication cable to the P1 P2 terminals (P1=red, P2=black).
Important: It is necessary for the Daikin Remote Controller to remain
connected to the P1 P2 ports of the unit.
3. Connect the power supply cable to the X35A connector.
4. Connect the power supply and verify the connection is correct.
The LED of the DKN WiFi Controller stays blinking in green when the connection is correct.
Note: To facilitate the access to the DKN WiFi Controller, place it in an accessible spot
.
11