TEFAL ULTRAGLIDE EASYCORD FV42 Serie Instructions D'opération page 8

1800123494 FV42XX-FV43XX FTD US_110x154 20/06/11 16:24 Page3
Use
To fill the water tank
• Unplug your iron before filling it and set the steam control lever to
fig.1
( ).
• Open the water tank filling inlet lid (
horizontal position and fill it with water (
• Close the water tank filling inlet lid.
Always use the Easycord
system for enhanced comfort
of use.
To adjust the temperature and the steam
• Adjust the temperature (see table below) by turning the temperature
control dial to the temperature select position (
• When the iron is plugged in, the temperature control light will remain
"on" until the temperature is reached (
reached, it will go "off".
• Adjust the amount of continuous steam output by moving the steam
fig.7
control lever (
levels.
F
ABRIC
L
INEN
C
OTTON
W
OOL
S
ILK
S
YNTHETIC
(Polyester, Acetate,
Acrylic, Polyamid)
• Your iron heats up quickly, therefore, begin ironing with fabrics that are
ironed at lower temperatures first, then go on to those requiring a
higher temperature.
In order to achieve the
maximum amount of steam, it
is recommended that you wait a
few seconds after you push the
burst of steam button again.
fig.2
fig.3 ).
• Your iron is equipped with the Easycord system to prevent the cord
from dragging across your garments and wrinkling just ironed
clothing.
• Press the button located on the base (
is automatically in use. You can now plug in your appliance and begin
ironing.
fig.6
). Once the temperature is
). See below table for recommended steam output
P S
OSITION OF
TEMPERATURE BUTTON
MAX
•••
••
•
• Press the Burst of Steam
fig.8
wrinkles (
), place the iron in a
To use the Easycord system
- It is normal for the
fig. 5 temperature indicator light to
).
turn on and off during ironing.
- In order to avoid water leaking
from the soleplate onto your
garment:
TEAM SETTING
POSITION
- When ironing fabrics with
mixed fabrics, set the iron
temperature for the most
delicate fabric.
- For delicate fabrics, we
=
STEAM ZONE
recommend testing the fabric
first on an inconspicious place
for example, inside the hem.
- If you want to iron without
steam, set the steam control
level to
To obtain more steam
button periodically to remove stubborn
).
3
Do not exceed the "MAX" fill
level as indicated on the water
tank of the iron.
fig.4
) and the Easycord system
Set the steam lever to
•
when ironing silk or
synthetic fabrics and set it to
for wool.
Should you need to turn
•
down the temperature, wait
until the temperature light
comes back on before
beginning to iron again.
.