Citronic AEL Serie Mode D'emploi page 7

Connect to mains power
Before plugging the unit in always make sure that the power supply matches the product specification
voltage. First connect the IEC end of the cordset to the IEC connector on the amplifier then plug the
other end of the cordset to the AC mains.
Please read instructions below for reliable and problem free use:
•
Be sure all connections made are made in the correct way.
•
Check if the connected speakers are compatible with the amplifier.
•
Ensure there is adequate ventilation.
•
Prevent exposure to moisture.
•
Never plug speakers in/or out while in use, this can result in serious damage.
Specifications
Specification
Ref. No.
4 Ohm Stereo Power (RMS)
8 Ohm Stereo Power (RMS)
8 Ohm Bridge Power (RMS)
Frequency range
THD @ 4 Ohm / 1 kHz
Dampings factor @
1 kHz / 8 Ohm
Signal to noise ratio (SNR)
Slew Rate
Input Sensitivity
Input Impedance
Power supply
Dimensions (bxhxd)
Weight
Note: Specifications and design are subject to change without notice for purpose of
improvement.
This product meets the requirements of the EMC and LVD Directives.
AEL-300
171.180
2x 150W
2x 100W
300W
482 x 230 x 88mm 482 x 230 x 88mm
8kg
7 - 32
AEL-600
171.183
2x 300W
2x 200W
600W
5Hz – 50kHz
<0.05%
>400
>95dB
40V/uSec
1.228V
20kOhm
230Vac / 50Hz
482 x 390 x 88mm
11kg
AEL-900
171.186
2x 450W
2x 300W
900W
12kg