Front Panel Features - Citronic AEL Serie Mode D'emploi

Features
Citronic Professional stereo audio amplifier featuring high output power and excellent value for money.
The CPA range of amplifiers are ideal for the starting DJ, smaller fixed installations in pubs, clubs
canteens etc. or as a complement in larger disco installations.
• Outstanding sound quality
• Protection against high temperatures
• Stereo and bridge mode
• Signal, Clip & Protect indication for each
channel

Front Panel Features

1. Cooling Vents.
Front to rear forced airflow.
2. Volume Controls.
These controls adjust the volume level of both channels. Turn slightly to the left when the clip
indicators (4) light up.
3. Protect Indication.
When on any given point, something damaging might occur to your amplifier, it will switch in protect
mode. The amplifier will disconnect the point where the damage is about to occur and switch on the
protection led to indicate to you that something is wrong. Reasons might be: Bad ventilation,
A low impedance (< 4 Ohm), Defect fan(s), A short circuit in cables.
4. Clip Iindication.
These LEDs will light up when one or both channels are on max power. It can occur that these
LEDs will lit up now and then, this is not a problem. But if it lights up continually you need to adjust
the volume down, otherwise permanent damage to equipment might occur
5. Signal indicators.
Three orange LEDs indicate the amplifiers output signal levels.
6. Power Indication.
This clear blue indicator will light when the amplifier is turned on.
7. On/Off Switch.
For switching the amplifier on and off. Always adjust the volume down to its minimum before
switching this amplifier on.
• Inputs via XLR & 6.3mm jack
Speaker NL4 & binding post outputs
•
Temperature controlled cooling fans
•
4 - 32