Rear Panel Features - Citronic AEL Serie Mode D'emploi

Rear Panel Features

1. Fan.
Front to rear forced airflow.
2. Fuse.
This main fuse secures the amplifier and
wires against defects. Replace this only
with a fuse of same type and value.
3. Mains Power Connector.
4. Ground Lift Switch.
Allows circuit and chassis grounds to be
separated in case of problems with earth
loops (hum).
5. Speaker Outputs NL4.
Maximum load in stereo/mono mode 4
Ohm per channel.
Pin +1 & +2 = + output, Pin -1 & -2 = -
output
6. Binding Post Output Jacks.
Maximum load in stereo/mono mode 4
Installation
Connecting Input
Both inputs are balanced. If a balanced output is unavailable, you can also use a unbalanced one,
connect pin 3 – with pin1 mass (see below). Unbalanced line may result in noise over long cable runs.
1= earth / mass, 2=signal +, 3=signal –
Ohm per channel. Maximum load in bridge
mode 8 Ohm.
7. Mode Switch.
The amplifier can use 3 different modes:
stereo, bridge & parallel (mono). Choose
one of these functions:
Stereo mode: Standard left/right stereo
mode.
Bridge mode: This mode combines both
amps on one channel which results in
double power on this channel. Connects
the signal to the left input channel and the
output level can now be adjusted with the
left volume control.
Balanced XLR inputs.
Two 3-pin female XLR input connector for
connecting a signal source (mixer etc.).
8. Balanced 6.3mm Stereo Jack inputs.
Two 6.3mm jack female input connector for
connecting a signal source (mixer etc.).
5 - 32