Fellowes Galaxy 500 Mode D'emploi page 5

CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from each side. For best results empty the tray regularly.
The tray should be emptied after every 50 operations to ensure no blockages occur.
STORAGE
Lower the lid and punch handle. The Galaxy comb binder is designed to be stored horizontally on the desk.
TROUBLESHOOTING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Partial holes
Missing holes
Sheets will not turn on the
bound document
Damaged hole edges
Waste tray leaks
WORLDWIDE WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship
for 2 years from the date of purchase by the original consumer. If any part is found to be
defective during warranty period, your sale and exclusive remedy will be repair or replacement,
at Fellowes' option and expense, of the defective part. This warranty does not apply in
cases of abuse, mishandling or unauthorised repair. Any implied warranty, including that of
merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the machine.
Cause
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch pattern
Selectable dies are not selected to punch
Back margin is too large for a smaller comb
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst
feature' has activated
Solution
Adjust edge guide until hole pattern is correct
Check waste tray in empty. Check for blockage to paper entry
Take stiff cardboard and slide into the paper entry. Move the
cardboard sideways to release any stray clippings into the
waste tray
Adjust edge guide and test punch scrap sheets until correct
Check the correct dies are selected to punch holes. To select a
die, push selector switch down at the front
Select the smaller margin depth for combs up to 18mm (
in diameter (2-150 sheets) Select the larger margin depth for
combs larger than 18mm (
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
Check waste tray is empty and 'burst feature' is closed
warranty period set forth above. In no event shall Fellowes be liable for any consequential
damages attributable to this product. This warranty gives you specific legal rights. You may
have other legal rights that vary from this warranty. The duration, terms and conditions of this
warranty are valid worldwide, except where different limitations, restrictions or conditions may
be required by local law. For more details or to obtain services under this warranty, please
contact Fellowes or your dealer.
")
11
/
16
11 ") in diameter (151-500 sheets)
/
16
5