Safety Summary; Installation - Hitachi PC-ARFHE Manuel D'utilisation

Safety summary

1 SAFETY SUMMARY
HITACHI cannot anticipate every possible circumstance that might involve a potential hazard.
!
D A N G E R
Perform electrical work according to the Installation Manual. As for the electrical wiring work and
check, turn OFF the main power supply before opening/closing the service cover of indoor unit. If
service cover is opened with main power supply left on, it may result in an electrical shock.
!
C A U T I O N
• DO NOT pour water into the remote controller. This product is equipped with electrical parts. If poured,
it will cause a serious electrical shock.
• DO NOT perform installation work and electrical wiring connection by yourself. Contact your HITACHI
distributor or dealer and ask them for installation work and electrical wiring by a service person.
• DO NOT install the product in places where oil vapour or oil are dispersed, in the vicinity of hot springs
(in a sulfuric environment), where the generation, flow, accumulation or leakage of flammable gas is
detected, or in salty, acid or alkaline environments.
• DO NOT install the controller and its cables within approximately 3 meters from strong electro magnetic
wave radiators such as medical equipment. In case that the controller is installed in a place where
there is electromagnetic wave radiation, shield the controller and cables by covering them with a steel
box and running the cable through a metal conduit tube.
?
N O T E
• The installer and system specialist shall comply with local regulations or standards for safety. The
following standards may be applicable, if local regulations are not in force: International Organization
for Standardization, ISO5149 or European Standard, EN378 or Japan Standard, KHKS0010.
• This appliance must be used only by adult and capable people, having received the technical information
or instructions to handle it properly and safely.
• Children should be supervised to ensure that they do not play with the appliance.
• Important: Please read and understand this manual before using this remote controller.
If you have any questions, contact your HITACHI distributor or dealer.

2 INSTALLATION

Select a suitable place for operation and determine the installation place of the controller
with the customer's acceptance.
Do not install the controller in a place where it is at the reach of children.
The controller has a built-in thermistor; do not install it in places where it may become
excessively affected by other equipment, such as indoor units, water pipes, radiators, etc.
Select an installation place where the average room temperature can be detected, where
the remote control is not directly exposed to the sun or heat sources, and where it is not
affected by outdoor air currents from opening and closing doors.
Prior to the installation work, ensure that surface is flat and sufficiently strong and then fix
the unit securely.
1 PMML0358B rev.0 - 12/2015