Step 4 : Manage Cables - LDLC ARM2 Guide D'utilisation

ARM2
6. Step 3 : Attaching the monitor to the plate
Increase washer (E) based on actual
situation.

7. Step 4 : Manage cables

1. Lower part : Press and pull
Upper part : Use both hands. Slightly push out both ends, one after the other.
2. Pull to release the cable covers
3. Place your cables
4. Put back the cable covers by clipping them on.
5. Put the cable cover (7) after you finish placing all the cables.
To adjust the monitor with
the supplied 5x5 allen Key
(G).
Adjust the monitor's height after installing. If
the monitor cannot stop at any height, please
use the supplied 5x5 allen key to adjust the
screw on the arm. To make the mount and
monitor's weight aqual and it can stop at any
height, please adjust the screw in «-» direction
when the monitor up and «+» direction when
it is down.
To adjust the monitor with the
supplied 4x4 allen Key (F).
EN
U S E R ' S G U I D E
F
±135°