Lancellotti ENFASI Manuel D'utilisation page 80

The unit must be coated in heat-resistant material
(minimum 90°C). If the appliance is installed close to
other units, the minimum space suggested in the
following diagram must be left.
Any adjoining wall surface situated within 200mm from the edge of any hob burner must be a
suitable non-combustible material for a height of 150mm for the entire length of the hob. Any
combustible construction above the hotplate must be at least 600mm above the top of the burner
and no construction shall be within 450mm above the top of the burner.
Where the distance from the edge of any burner to a horizontal surface is less than 200mm, the
surface must be either: 10mm (min) below the level of the hob, or have the vertical component of
the surface suitably covered with a non-combustible material as specified in AS 5601 - AG 601.
80
Instructions for the installer
Using flexible rubber pipes with a max. length of 1500 mm:
• do not allow the pipes to be constricted or crushed;
• pipes must not be subject to tractive force or torsional stress;
• do not allow the pipes to come into contact with cutting or sharp edges, etc...
• do not allow the pipes to come into contact with parts that can reach temperatures of 70°C
above room temperature;
• make sure the entire length of the pipes can be inspected;
• do not use the Natural Gas Regulator supplied with the appliance for Propane Gas.