Pan Recognition - Lancellotti ENFASI Manuel D'utilisation

Instructions for the user
7.5

Pan recognition

An electronic sensor detects if a pan is present or absent on the radiant element. If the type of pan
is unsuitable for magnetic induction cooking (see section " 7.5.1") or if the pan is too small (see
table "
MINIMUM DIAMETER
If during cooking a pan is removed from the radiant element without having first returned the
relative knob to "0" position, the power value, previously set and shown on the relative display, will
be automatically replaced with the symbol
If the pan is repositioned correctly on the radiant element, the symbol
will resume normally; otherwise, after 10 minutes, the symbol will switch off, the knob will have to
be returned to "0" position and a new power value set before the radiant element can be used
again.
If a knob is turned to any position before placing a pan on the radiant element, the relative display
shows the set power value and then immediately replaces it with the symbol
stands by for 10 minutes). If in the meantime a pan is placed correctly on the radiant element,
cooking will begin; otherwise the radiant element does not activate and symbol
reactivate the radiant element, the relative knob must be returned to "0" position and a new power
value set.
Pan recognition limits: the diameter of the pan base is signalled by a circumference or perimeter
on the cooking zone.
1
Ø 145
MINIMUM
120
DIAMETER
(mm)
" on p. 103), the adjacent symbol is displayed.
.
2 3
Ø 180 Ø 260
145 180
switches off and cooking
4 5
Ø 210 Ø 200
145 145
(the radiant element
switches off. To
6 7
220
Ø 230
180 145
103