Chart Positioning; Changing The Felt Tip Pen On The Pen Arms - Anderson The Guardian III Manuel De L'opérateur

Table des Matières

Publicité

Chart Positioning

When placing a new chart on the Guardian, align the correct time of day to the "START TIME"
marker located in the lower right hand corner.
Changing the Felt Tip Pen on the Pen Arm
You will need to periodically change the felt tip pen on your Guardian. You will know this needs
to be done when the chart is moving, the pen is in contact with the paper but the line is either faint
or not printing at
all. Replacement
pens are available
your dealer. See the
"Customer Support
and Replacement
Parts" section for
part numbers when
ordering.
To change a pen,
simply slide the felt
tip marker off the end
of the metal pen arm.
Slide a new one on until
it "clicks" in place.
Anderson Guardian
Installation
Slide pen into
holder (1) and
push down (2) as
shown by arrows.
1
Removal
To replace, pull up
at back end (1)
and push out (2).
Note: Be sure to replace the pen cartridges with the same type (color) that was
Note: Be sure to replace the pen cartridges with the same type(color) that
removed. Be careful not to bend the pen arm while changing the pens.
was removed. Be careful not to bend the pen arm while changing the pens.
For five replacement pens, order the following:
Green # 60500401
For five replacement pens, order the following:
Red
#60500402
Black
#60500408
Red
#60500402
2
1
2
7

Publicité

Table des Matières
loading

Table des Matières