Appendix; Programming Your Guardian; Programming Overview; Changing Parameters In Program Mode - Anderson The Guardian III Manuel De L'opérateur

Table des Matières

Publicité

VIII Appendix

Programming Your Guardian

Programming Overview

Your new Guardian recorder should be installed by a qualified professional. Most parameters will be
factory programmed, or fine tuned at time of startup by the Installer. Future changes on items such as
recording time, farm ID or real time clock are updated via menu items shown in this section.
If you have a questions, feel free to call your Installer, or Anderson directly at 800-833-0081 before
making program changes

Changing Parameters in Program Mode

NOTE: When the MODE switch is placed in the Prog position the unit will stop rotating the chart and
relays will de-energize.
The recorder setup programming can only be accomplished when the mode slide switch is placed in the
PROG/TEST/CAL position, or the left position. This switch is located left of the display and is behind
a sealed cover.
In the PROG/TEST/CAL mode, the keys will function as follows.
SCROLL
When a mode or section designation is displayed, SCROLL steps to the next mode
or section. When a parameter code is displayed, SCROLL will display the
corresponding parameter value. When a parameter value setting is displayed,
SCROLL will display the next parameter code.
DOWN ARROW
When a mode or section designation is displayed, DOWN will enter that mode
or section. When a parameter code is displayed, DOWN will display the next
parameter value. When a parameter setting is displayed, the setting will
decrease, unless it is at a limit value.
UP ARROW
When a mode or section designation is displayed, UP will have no effect. When
a parameter code is displayed, UP will revert back to the section designation.
When a parameter setting is displayed, the setting will be increased unless it is
at a limit value.
To enter the PROG/TEST/CAL mode, the cover plate must be opened and the switch moved to the up
position. The unit will display Prog. Subsequent depressions of the SCROLL will cause the unit to
display TEST, then CAL, and then back to Prog (Program).

Main Menu

Anderson Guardian
tESt
ProG
CAL
13

Publicité

Table des Matières
loading

Table des Matières