Sommaire des Matières pour Anderson The Guardian III
- Page 1 The Guardian III Farm Bulk Tank Recording Thermometer Operator’s Manual GUARDIAN FormAIC2054 © November 2007 Revised: 5/12/11...
- Page 2 Note to Dealers: Once you have installed the Guardian and initiated operation, please leave this manual with the dairy producer. Thank You, Anderson Instrument Anderson Guardian...
-
Page 3: Table Des Matières
18 • Relay Outputs p. 18 • Power Requirements p. 18 • Construction p. 18 • Environmental and Operating Conditions p. 18 • General Reference Data p. 18 • Approvals and Compliance p. 18 VIII Warranty p. 19 Anderson Guardian... -
Page 4: I Overview
Finally, all models are equipped with alarm relays that can be used for signaling problems. These relays can be wired by your installer to an external light, horn, or auto-dialer to alert you of an over- temperature condition so you can remedy it before it becomes critical. Anderson Guardian... -
Page 5: Getting To Know Your Guardian
Getting to Know Your Guardian NEMA 4X enclosure for washdown applications Chart hub clamp Platen Tabs to hold chart in place Pen arms and felt tip pens Sealed Latch calibration cover LED Display Keypad Scroll Sensor probe and wire Anderson Guardian... -
Page 6: Regular Maintenance
5. Close the black chart hub clamp and then press the DOWN arrow button. The unit is now back in normal operation. The display will change back to the tempera- ture. Close the recorder door and secure the latches. Keypad on the Guardian III Anderson Guardian... -
Page 7: Chart Positioning
Be careful not to bend the pen arm while changing the pens. Slide a new one on until For five replacement pens, order the following: it “clicks” in place. Green # 60500401 For five replacement pens, order the following: #60500402 Black #60500408 #60500402 Anderson Guardian... -
Page 8: Changing The Rotation Time Of The Chart
11. Install the new replacement chart onto the instrument. Be sure to use the chart which corresponds to the new chart speed that was just programmed. For example, if chart speed is programmed for 7 days, choose a 7-day chart. Close the door of the Guardian. You are ready to go! Anderson Guardian... -
Page 9: Calibration Check
7. If the recorder temperature on the chart and the LED display are the same but are not within .75°F (1°C) of 32°F (0.0°C), an input calibration should be performed. Please consult your Dealer for assistance with the calibration procedure. Anderson Guardian... -
Page 10: Pen Alignment
14. Repeat steps 7 through 12 for pen 2 (black pen). 15. Move the MODE switch to the RIGHT position. Replace the small cover over the MODE switch and secure with the screw provided. If you have any additional questions concerning calibration, please consult Anderson at 1-800-833-0081. Anderson Guardian... -
Page 11: Troubleshooting
The chart is rotating, but there are two red and black lines forming a circle around the chart. You need to change the chart. See the section titled “Changing your Chart” for chart changing instructions. You are concerned that the Guardian (red and/or black pen) is not accurately recording milk temperature. Do a calibration check on the Guardian. See “Calibration Check” section in the Regular Main- tenance Section of this manual. Anderson Guardian... -
Page 12: Customer Support And Spare Parts
VII Customer Support and Spare Parts Call your local dealer or Anderson Instrument Inc. at 1-800-833-0081 for ordering spare parts. CONSUMABLES CHARTS 24 hour / °F 00215709 48 hour / °F 00215710 72 hour / °F 00215711 7 day / °F 00215712 24 hour / °C... -
Page 13: Appendix
Installer. Future changes on items such as recording time, farm ID or real time clock are updated via menu items shown in this section. If you have a questions, feel free to call your Installer, or Anderson directly at 800-833-0081 before making program changes Changing Parameters in Program Mode •... -
Page 14: Program Menu Flowchart
Program Menu Flowchart • Anderson Guardian... -
Page 15: Program Menu Parameters
• Value representing hour • IIIN Value representing minutes • Fid1 First four digits of Farm Identification Number • Fid2 Second four digits of Farm Identification Number Boot • Caution - this menu option for Factory Setup only Anderson Guardian... -
Page 16: Canadian Quality Milk Guidelines - Smart Alarm Feature
Down Arrow on display every 90 minutes until milk pick up. The tank boom switch is in the wash position 30 AL09 Down Arrow on display seconds after the start of the first milking. AL10 Power Down AL11 Power Up Anderson Guardian... -
Page 17: Specifications
Chart Rotation Accuracy 0.5% of rotation time, assuming all backlash removed • OPERATOR INTERFACE Display Four digits 0.56” high, red, seven segment, LED display Status Indicators Error codes shown on Main display Keypad Three keys for programming and unit operation Anderson Guardian... -
Page 18: Alarms
Up to 30 degrees forward or backward tilt from vertical up to 10 degrees side tilt from vertical • GENERAL REFERENCE DATA Data Backup Non-volatile memory for configuration parameters, calibration data and alarm setpoints, non-volatile memory for alarm data Warranty Two year • APPROVALS AND COMPLIANCE Safety UL/CUL Approval Pending Anderson Guardian... -
Page 19: Warranty
SPECIFICALLY AGREES OTHERWISE IN WRITING AFTER THE PROPOSED USAGE HAS BEEN MADE KNOWN TO IT. THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE. Anderson Guardian... - Page 20 GUARDIAN Anderson Instrument Company, Inc. 156 Auriesville Rd. Fultonville, NY 12072 800-833-0081 Anderson Guardian...