Attaching The Toys; Assembling The Art Table - Stage 2 - Evenflo ExerSaucer Instructions

Centre d'activités 2 en 1 et tablette d'artiste
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Attaching the Toys

WARNING
Toys with cap MUST be in place
when Stage 1 is in use.
Tab
Toy Cap
CLICK!
Dimple
To place toy with cap on ExerSaucer, set
toy cap on top of Leg, as shown. Push
down until tab rests in dimple on Leg to
ensure toy is attached properly.
To remove toy from ExerSaucer, grab cap
and pull straight up.
CLICK!
Toy Base
WARNING
Secure Spin-Loc™ toys every time the
ExerSaucer is used.
To secure Spin-Loc toys on ExerSaucer Tray,
, slightly moisten suction cups with damp
cloth and set toys on Tray in a flat location,
then push down in center then twist toy base
clockwise until it clicks or until you hear the
click, as shown. Pull up on toys to make sure
they are locked in place.
If Spin-Loc toy does not stay attached, clean
suction cup per cleaning instructions for plastic
parts on page 9.
To remove Spin-Loc toys from ExerSaucer Tray,
twist toy base counterclockwise and Pry up the
bottom of base, as shown. You may need to
use a card or flat tool to break the suction from
the tray.
Note: If Spin-Loc toy does not lift off Tray,
continue twisting toy base counterclockwise
until toy base releases.
6
Screws
To remove batteries from mirror toy,
remove two screws, and lift mirror face.
To replace mirror face, replace screws.
DO NOT OVERTIGHTEN.
WARNING
STAGE 2
Stage 2 is for use by children who can walk unassisted
up to approximately 48 months.
Stage 2 Art Table MUST be in highest position at all times.
Base
Base
Bounce
Ring
Tab
Attaching the Toys
3-AAA
Batteries
Refer to battery door
for quantity and size
of batteries.
Remove screw from battery door.
Replace screw after batteries have been
replaced. DO NOT OVERTIGHTEN.
Assembling the Art Table
STAGE 2
Note: Remove all toys from ExerSaucer
before assembling the Art Table.
1. Remove Base from bottom of
ExerSaucer.
2. Turn ExerSaucer upside down.
3. Remove Bounce Ring from Tray. Push
tab until it releases from Tray. Repeat
until all six tabs are released from Tray.
7
Screw

Publicité

Table des Matières
loading

Table des Matières