Setting Up The Changer; Attaching The Console - Evenflo AERIS BabySuite Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTING UP THE CHANGER (continued)
3
D
A
B

ATTACHING THE CONSOLE

Not available on all models.
Option A:
To securely attach the console
to the
A
playard, push each clip
onto the top of the
B
playard, as shown.
B
6
To remove the changer
from the playard, unfasten the two
A
snaps
on the changer skirt. Pull up on each fastening clip
D
Raise the changer up and away from the playard.
Option B:
To securely attach the console
push clips
through the openings
B
changer and onto the top of the playard.
A
C
B
A
B
1
.
B
B
2
A
C
to the playard,
A
in the
C
3
4
E
A
Remove the console, mattress pad and/or bassinet.
1. Rotate the loop
A
up to 90°.
2. Lift up on the loop until the feet
as shown.
2
B
1
90°
Find the center of one of the top rails
hard on the fold lock release button inside the padded rail to
release the lock.
Make sure that both sides of the rail unlock properly, then
push the rail downward and fold completely. Repeat for the
remaining three top rails.
Note: If the top rail will not fold completely, lift up on the loop
attached to the center of the floor and try again.
A
Gather the sides of the playard together.
Note: If the sides do not easily fold up, repeat steps 1 and 2,
making sure all side rails are unlocked.
D
To disassemble the bassinet
the tubes
Note: The tubes cannot be removed from the
bassinet.
FOLDING UP YOUR PLAYARD
attached to the center of the floor
are drawn together,
B
. Lift up and squeeze
C
, disconnect
D
, as shown.
E
7

Publicité

Table des Matières
loading

Table des Matières