Evenflo ExerSaucer Instructions page 4

Centre d'activités 2 en 1 et tablette d'artiste
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Assembling the ExerSaucer
Base
Base
Base Cap
Seat Ring
Wheel
Holders
6. Place Seat Ring upside down and locate the wheel holders
Click six (6) Seat Wheels into wheel holders, as shown.
Triangles
Seat
Seat Ring
Triangles
7. Align triangles on the back of the Seat Ring with the triangles on the seat
pad label. Snap the plastic tabs on the pad over the pegs on the Seat Ring.
Continue this process until all tabs are attached to all pegs.
To remove Seat Pad:
Un-clip plastic tabs from pegs on the Seat Ring and lift out.
4. After all four Legs are locked in place,
turn the ExerSaucer right-side-up.
5. Place Base on Legs under the
ExerSaucer. Make sure the Base is
resting in the notches on the Legs, as
shown. Then place the Base Cap in the
Legs
center of the Base.
IMPORTANT: Base MUST be in place
before using Stage 1. Base Cap MUST
be placed in the Base with the rim
facing down, as shown.
Seat Wheels
CLICK!
CLICK!
4
Seat Ring
Triangles
During use, allow the baby's toes only to touch the Base. DO NOT allow
the baby to stand flat-footed on the Base. As baby grows and becomes
more active, raise the Tray to the next level so that baby enjoys the most
comfortable fit and maximum use of the spin, and bounce features.
Plastic Tabs
To adjust height:
ALWAYS remove baby from ExerSaucer before adjusting. Squeeze tabs while
unscrewing Hand Lock. Unscrew only far enough to free the Hand Lock from the
opening in the Tray. Move the Tray up or down to the desired height, then tighten
the Hand Lock until finger tight. DO NOT OVERTIGHTEN.
IMPORTANT: When inserting Hand Locks, use the same opening in each Leg
Assembly, or the ExerSaucer will not be level.
Pegs
Tabs
Assembling the ExerSaucer
8. With the triangles
on the Seat Ring
facing away from
you, tilt Seat
Ring and place in
Bounce Ring, as
shown.
Squeeze both sides
until two tabs lock
in place with an
audible click.
Bounce Ring
Seat Ring
9. Reach under Seat Ring and pull inner
edge toward center of Seat Ring. At the
same time, push down on the front of
the Seat Ring until the third tab locks
in place with an audible click. The Seat
CLICK!
Ring should spin freely.
WARNING
Loosen
Hand
Lock
5
CLICK!
CLICK!
Tighten

Publicité

Table des Matières
loading

Table des Matières