Instructions For Use; Cleaning And Maintenance; Trouble Shooting - Sonnenkonig VENTUS 200 Mode D'emploi

5. Instructions for use

• Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
EN
environments and flammable objects.
• Connect the fan heater to the mains.
• Set the thermostat knob to MAX and let the heater operate with full power.
• The fan heater will switch on when the heating selector is set to one of the power settings.
• Once the room reaches the required temperature, the heating element will stop working but
the fan keeps working. Once the temperature decreases, the heating element will start working
again. The fan heater now starts and stops automatically and thus keeps a constant room tem-
perature.
• Before you switch off the heater, please turn the thermostat to the MIN position and turn the
switch to the fan position. Let the appliance cool down for two minutes, then turn off the heater
and pull out the plug.

6. Cleaning and Maintenance

• Before cleaning the appliance, disconnect it from the socket and let it cool down. The housing
gets dirty easily, so often wipe it with a soft sponge. Wipe the dirty parts with a sponge dipped
in < 50° C water and a mild detergent, then dry the housing of the heater with a clean cloth. Be
careful not to let the water get inside the appliance. Do not splash water onto the heater, never
use solvents like gasoline, etc. to clean the heater in order to protect the housing.
• Clean the cord and plug, dry and pack it in a plastic bag.
• When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put
it in a packing box and store it in a dry, ventilated place.

7. Trouble shooting

You can solve many common problems easily, saving you the costs of a possible service call. Try
the suggestions below to see if you can solve the problem before calling the service centre.
Problem
The heater does not operate,
even when it is plugged in
and the switch, thermostat are
switched on.
Possible cause
The plug is loose, bad connec-
tion
No power in socket outlet
36
Treatment
Pull out the plug, check the
connection of the plug and
socket. Then connect again.
Insert the plug in a proper
socket