BGS technic 1609 Mode D'emploi page 6

OPERATION
1. Connect the threaded side of the pressure oil hose to the pressure oil connection (2) of the
hydraulic pump.
2. Connect the coupling side of the pressure oil hose to the selected tool.
3. Insert a compressed air nipple into the compressed air connection (4) of the hydraulic pump.
4. Connect the hydraulic pump to a source of compressed air.
5. To maintain the correct operating characteristics, the air supply must be 140-280 L/min at 6.9 bar.
Furthermore, the compressed air source must be equipped with a filter unit.
6. Check all hoses and connections before using the hydraulic pump.
7. Press the pressure build-up pedal (B), the pump is started and generates the required oil pressure
to operate the tool.
8. Press the pressure release pedal (A) to lowers the oil pressure.
Note: Never operate the hydraulic pump without a hydraulic tool connected. In this state, the hose
and the connections are put under high pressure. This increases the risk of bursting and can damage
the pump and its components.
MAINTENANCE

Inspect hoses and connections before using the hydraulic pump.

If necessary, tighten the connections.

Check the hydraulic oil level. Use only good quality hydraulic fluid.
We recommend Mobil DTE 13M or equivalent.

Use a light machine oil to lubricate pivot points.

Clean the hydraulic pump with a soft and dry cloth.
STORING

Depressurize the hydraulic pump and disconnect hydraulic hose from hydraulic tool.

Clean the hydraulic pump with a soft and dry cloth.

Store the hydraulic pump in a clean and dry environment.

Store the hydraulic pump in a place out of the reach of children.

Avoid extremely high or low temperatures when storing.
ADDING HYDRAULIC OIL
1. Depressurize the hydraulic pump and disconnect hydraulic hoses from hydraulic tool.
2. Make sure that the pump is in upright, horizontal position.
3. Remove the oil filler plug, this is located on the top plate of the oil tank.
4. Use a small funnel (19mm) to fill the oil tank.
5. Never use brake fluid, glycerine, transmission, turbine, or motor oil.
6. Use only good quality hydraulic fluid. Use of other than good quality hydraulic oil will void warranty
and damage the pump, hose, and hydraulic tool.
7. Wipe up any spilled fluid and reinstall the oil filler plug.
CHANGE HYDRAULIC OIL
1. For best results, change fluid once a year.
2. Remove the oil filler plug, this is located on the top plate of the oil tank, then pour used fluid into a
sealable container.
3. Fill with a good quality hydraulic oil as recommended above and reinstall oil filler plug.
4. Dispose of the used oil properly via a waste oil disposal company or inquire at your waste
authority.
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally. Recycle unwanted
materials instead of disposing of them as waste. All tools, accessories and packaging
should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment. Contact your local solid waste authority for recycling
information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed