Blower Operation - Black & Decker BV3100 Manuel D'instructions

rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and
collection bag in place.
• Always switch off and remove the plug from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or working on blower/vac.
use blower/vac only in daylight or good artificial light.
swiTCHing on and off (figure e)
warning:
use boTH Hands To grip THe produCT
firmly wHen swiTCHing on.
warning:
The tool will
continue to run for
approximately 5 seconds after it
has been switched off. Use both
hands to grip the tool and let the
motor come to a complete stop
before setting the tool down.
Your blower vac is fitted with a two
speed switch located on the top of
the power head below the handle.
• To use in low speed, rotate on/off switch (2) clockwise to Position
"i". To use in high speed, rotate on/off switch (2) clockwise to
Position "il".
• To turn tool OFF, rotate on/off switch (2) counterclockwise to the off
position "0".
eXTension Cord reTainer (figure f)
A cord retainer is incorporated into the rear of the power head. It
can be used in two different ways:
E
• To use the cord retainer as shown
in figure F1, insert the extension
cord into the cord retainer housing
from the side. Loop the extension
cord around the retainer so it rests
in the cord retainer. Then plug the
cord from the power head into the
extension cord.
• To use the cord retainer as shown in
figure F2, loop the extension cord
over the power head cord and plug
the two ends into each other.
Next, insert the extension cord into the cord retainer housing from
the side. Loop the extension cord around the retainer so it rests in
the cord retainer.

blower operaTion

CauTion:
Always wear safety
glasses. Wear a filter mask if the
operation is dusty. Use of gloves, long
pants and substantial footwear is
recommended. Keep long hair and loose
clothing away from openings and
moving parts. THIS BLOWER IS FOR
HOUSEHOLD USE ONLY.
noTe: Ensure the blower is switched
off and disconnected from the power
supply before attaching or removing the blower tubes. The blower
tube must be assembled to the housing before use.
• Hold the blower with both hands as shown in figure g and sweep from
side to side with the nozzle several inches above the surface. Slowly
advance keeping the accumulated pile of debris in front of you.
6
F
F1
F2
G