Blower Operation - Black & Decker LB700 Manuel D'instructions

A
OPERATION
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF THE OPERATION
IS DUSTY. USE OF RUBBER GLOVES AND SUBSTANTIAL FOOTWEAR IS
RECOMMENDED WHEN WORKING OUTDOORS. FOR HOUSEHOLD USE ONLY.
Use blower only in daylight or good artificial light.
SWITCHING ON AND OFF (FIGURE B,C)
WARNING:
USE BOTH HANDS TO GRIP THE PRODUCT
FIRMLY WHEN SWITCHING ON.
CAUTION:
DO NOT POINT UNIT DISCHARGE AT SELF OR BYSTANDERS.
WARNING:
The tool will continue to run for approximately 5
seconds after it has been switched off. Use both hands to grip the tool
and let the motor come to a complete stop before setting the tool down.
Your blower is fitted with a on/off switch located on the top of the
power head handle (6).
• To switch the blower on, slide the on/off (1) switch forward as
shown in figure B.
• To switch the blower off, slide the on/off (1) switch back as shown
in figure C.
B C
EXTENSION CORD RETAINER (FIGURE D)
A cord retention hook is incorporated into the rear of the power head.
• To use the cord retention hook (5) as shown in figure D, insert the
extension cord into the cord retainer housing from the side. Loop the
extension cord around the retainer so it rests in the hook of the cord
retainer. Then plug the cord from the power head into the extension cord.
D

BLOWER OPERATION

CAUTION:
Always wear safety glasses. Wear a filter mask if the operation is
dusty. Use of gloves, long pants and substantial footwear is recommended. Keep long
hair and loose clothing away from openings and moving parts. THIS BLOWER IS
FOR HOUSEHOLD USE ONLY.
NOTE: Ensure the blower is switched off and disconnected from the power supply before
attaching or removing the blower tube. The blower tube must be assembled to the housing before use.
• Hold the blower steady and sweep from side to side with the nozzle
several inches above the surface as shown in figure E. Slowly advance,
keeping the accumulated pile of debris in front of you.
E
5
5