Adjusting The Oven Burner Air Adjustment Shutters - Samsung NX58M6850S Serie Manuel D'installation

Adjusting the oven burner air adjustment shutters

Air
adjustment
shutter
To check and adjust the oven burner air adjustment shutters:
1. Open the oven door.
Remove the oven racks.
2.
3. Remove the oven floor.
4. Press the Bake pad, then the START pad.
5. After the oven has lit, visually check the flames coming out of the upper and
lower burners. If adjustment is needed, carefully adjust the air adjustment
shutters.
Install_NX58M6850SS_DG68-00910A-02_EN+MES+CFR.indb 25
All oven burners have an air adjustment
shutter. The purpose of the shutter is to
regulate the flow of air to the flames.
Properly adjusted flames should burn
steadily with approximately 1-in of blue
cone. The flames should never extend
past the edge of the burner baffles. Even
though these are preset at the factory, they
should be checked and, if needed, adjusted
periodically to ensure efficient operation.
The shutters are located at the base of the
burner manifolds near the back oven wall.
To adjust the shutter, loosen the locking
screw and rotate the shutter towards the
open or closed position as needed. If flames
are lifting off the burner ports, gradually
reduce the air shutter opening until the
Locking screw
flames are stabilized.
If flames are too yellow and/or too large,
gradually increase the air shutter opening
until the flames have approximately a 1-in
blue cone.
NOTE
If the range is set up for natural gas, the
flames should burn with no yellow tipping.
If the range is set up for LP gas, small
yellow tips at the end of the cones are
normal.
After the flames are adjusted properly, shut
off the oven, retighten the locking screws,
replace the oven bottom and racks, and
close the oven door.
Locking
screw
English 25
2017-12-13 5:21:58