Samsung NX58M6850S Serie Manuel D'installation page 24

Installation instructions
Checking the flame quality:
All combustion flames need to be visually checked to determine their flame
quality.
1
2
3
24 English
Install_NX58M6850SS_DG68-00910A-02_EN+MES+CFR.indb 24
1. Soft blue flames—Normal for natural
gas operation.
2. Yellow tips on outer cones—Normal for
LP gas operation.
3. Yellow flames—Abnormal for any gas
operation; call for service.
NOTE
If burner flame looks like 3, the range
should not be used until it is serviced. Call
for service. Normal burner flames shall look
like 1 or 2, depending on the gas type you
use.
Step 9. Final installation checklist
You have just completed installing your range. Make sure all controls are in the off
position and the flow of ventilation air to the range is unobstructed. The following
is a checklist to confirm your range is safely installed and ready for operation.
•
•
Gas Range Plug
•
•
•
•
Locking screw •
Gas line has been properly connected
to the range. The gas has been turned
on. All connections have been checked
for leaks.
Range is plugged into the properly
grounded electrical receptacle.
Approved anti-tip bracket is properly
installed and engaged with the range.
Range is leveled and is firmly sitting on
a solid, level floor.
Gas surface burners have been properly
assembled.
All burners have been tested for proper
operation.
FOR INSTALLER ONLY—Check and/or
adjust the broil and oven burner flames
as described on page 35-36 in this
manual.
2017-12-13 5:21:57