Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bedienungsanleitung / Owner Manual 4000 Pro
15
T r o u b l e s h o o t i n g
The unit does not start:
Check the engine fuel or for electrical units the
supply plug fuse and supply.
Check all the safety switches and ensure that they
are correctly installed as they will prevent the
engine starting. If you cannot solve the problem,
please contact your dealer.
The electric engine stops after short
period:
The motor could be over heated so that the
thermostatic cut out has operated. In this case,
wait until motor has cooled down and try again If
the supply plug is hot, please check the cable
diameter
(5 x 1,5mm) and the correct fitting of the wires
into the plug.
Note:
Use only short cable with a conductor size of 1,5mm
or greater. Long cables cause both voltage drop and
an increase in current which way blow fuses
Engine will not run at full speed or gives
sings of distress:
Check that the hammer mill shaft can turn freely
and clean the area to ensure that no blockage can
occur.
Correct the belt tension if necessary.
If the unit still does not work, please contact your
dealer.
V-belt tension
You should check the V-belt tension more frequently
when the machine is new and then, thereafter, at
regular intervals of no more than 4 hours. The V-
belt tensioner is located towards the bottom of the
machine and can be accessed by slacking the lock
nut. the tension of the V - belt can be adjusted by
taking up the tension of the screw provided.
Chopped Material is too fine for intended
use:
If the horizontal screen is refitted, remove it by
folding it down.
Check the hammers. If edges are blunt, turn or
change them to sharp edges.
If the side hopper is in use, check the cutter blades
and sheer bar. Sharpen or change these as
necessary. Ensure that the clearance between the
cutter blade and sheer bar is 2mm, shim to correct.
TAM AG, 8637 Laupen
www.tamag.ch
Publicité
Table des Matières
