Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bedienungsanleitung / Owner Manual 4000 Pro
A s s e m b l y I n s t r u c t i o n s
Place the unit in the vertical position as shown.
1. Fit the wheel axle to the base machine using
the screws shown but do not tighten up. .
2. Slide the mudguard into position between the
chassis and axle brackets. Now fully tighten the
four fixing bolts.
3. Attach the wheels to the axle and secure using
washers and split pins.
4. Lift up the foot stand (as shown arrowed) and
tighten the fixing screws.
5. Fit the two handles to the chassis, tighten the
fixing screws and rotate the machine into a
horizontal position..
6. Attach the main hopper to the top of the
machine using the hinges and the short black
hand screw supplied.
7. Attach the discharge hopper, snap it shut and
fix using one long black hand screw.
8. Secure the side hopper with the collar bolt and
secure with the second long black hand screw.
Fill the petrol engine with correct grade oil as
shown in the engine manual and full before
attempting to start.
Important:
Do not attempt to use this machine without
having
first
studied
Operators
manual
Instruction Information and safety features.
Safety devices
1. You will find safety switches (3) + (4) located on
the side hopper as well as on main intake
hopper and the discharge cover. Safety screws
(1) + (2) operate the switches, so that the
machine cannot start until all hoppers and
covers are all correctly fitted.
Under no circumstances should any changes be
made to any of these safety devices.
In both hoppers there is a rubber flap to prevent
material being ejected. The should be inspected on
a regular basis and replaced when worn.
A feed tool is provided to enable leaves and bulky
material to be safely fed into the mach ine. This is
stored at the side of the main
TAM AG, 8637 Laupen
both
the
Engine
and
the
Shredder
www.tamag.ch
12
Publicité
Table des Matières
