General Notes - Rollei HS Freeze 6 Instructions

Operation
32
Delay Mode
In this mode you can set a delay time . The flash will fire then after this time is over .
This is used for example if you want to take a picture with some ambient light, but
you don't want to set the flash on the front nor the rear curtain . This might be used
if you want to have motion in your picture but one single motion in the middle of
the complete time should be sharp . Then you can set your camera's shutter time
and calculate the correct delay time that you can enter in the flash menu . Therefore
enter the delay mode and set the time between 00 .00 and 30 .00 seconds . A longer
delay is not possible .

General Notes

1 . Freeze Mode can only be used in manual (M) mode and it is specialised in the
shortest flash duration .
2 . If the wireless remote control function is activated (TTL-C / TTL-N / TTL-S / TTL-F),
the flash can only be controlled by the corresponding transmitter that is available
as an optional accessory .
3 . If the wireless remote control function U7 is activated, the flash can only be con-
trolled by the transmitter U7 which is available as an optional accessory . Please
note that this transmitter does not support High Speed Sync or Freeze Mode .
4 . If the systems overheats, it will automatically go into the overheat protection
mode . The display will show „OH" which indicates that the overheat protection
programm is activated . In this event the system will stop working . As soon as the
temperature is back to an acceptable level, the flash will start working again .
5 . If you start the continuous shooting mode in your camera, the flash power output
range is only available from 1 .0 to 3 .0 . Please note that the flash itself does not
have a continuous shooting mode and there will be no corresponding icon on the
flash display .
ENGLISH